microcontroller:esp8266:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
microcontroller:esp8266:start [2022/03/03 11:39] – created illu | microcontroller:esp8266:start [2022/03/03 11:48] (current) – illu | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== ESP8266 ====== | ====== ESP8266 ====== | ||
- | {{: | + | i bought some nice esp8266 |
- | {{: | + | {{: |
- | {{: | + | with an CH341 serial uart usb adapter to programm with the arduino ide. u can use this driver or search through google. |
+ | {{ : | ||
+ | |||
+ | {{: | ||
+ | |||
+ | for uploading code, you need to ground gpio0 and gnd to get the esp into program mode. | ||
+ | i just used some staple pins to connect each other, sure better is a resistor, but the pins where too fat: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
- | {{: |
microcontroller/esp8266/start.1646303994.txt.gz · Last modified: 2022/03/03 11:39 by illu