microcontroller:esp8266:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
microcontroller:esp8266:start [2022/03/03 11:44] – illu | microcontroller:esp8266:start [2022/03/03 11:48] (current) – illu | ||
---|---|---|---|
Line 4: | Line 4: | ||
{{: | {{: | ||
+ | |||
+ | with an CH341 serial uart usb adapter to programm with the arduino ide. u can use this driver or search through google. | ||
+ | {{ : | ||
{{: | {{: | ||
- | with an CH341 serial uart usb adapter | + | for uploading code, you need to ground gpio0 and gnd to get the esp into program mode. |
+ | i just used some staple pins to connect each other, sure better is a resistor, but the pins where too fat: | ||
{{: | {{: | ||
{{: | {{: | ||
+ |
microcontroller/esp8266/start.1646304261.txt.gz · Last modified: 2022/03/03 11:44 by illu